IEI Integration UPC-12AH_GM45 v2.00 - Manual (Page 121)

UPC-12A/GM45 Panel PC
Page 109
Other functions can be set in the SETTING tab, including:
Check to disable the buzzer that warns when the system is switching to
battery power.
Check to enable the LAN for remote monitoring function.
Check to enable the remote computer to turn the system power on or
off. (This function is not available at this stage)
Set the battery capacity parameter for the system to shut down automatically when the battery is
low. In this case, the system will shut down automatically when the battery capacity is below 5%.
7.3 Remote Control and Monitoring
The UPC-12A/GM45 can be controlled (power on/off) and monitored the battery status
through a remote computer located in the same subnet with the UPC-12A/GM45. To
control and monitor the UPC-12A/GM45 remotely, follow the steps below.
Step 1: Connect the RJ-45 remote LAN connector on the bottom panel of the
UPC-12A/GM45 to a local area network connector. Or connect the RJ-45 to
COM port cable to the “Remote RS-232 connector” and connect the DB-9
connector to the systems. (
629H629H629H629H628H628H
Figure 7-16 )
Figure 7-16: RJ-45 Remote LAN Connector