IEI Integration UPC-12AH_GM45 v2.00 - Manual (Page 63)

UPC-12A/GM45 Panel PC
Page 51
Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat panel
PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
flat panel PC. The flat panel PC arm mount retention screw holes are shown in
567H567H567H567H567H567H
Figure 4-20 .
Figure 4-20: Arm Mounting Retention Screw Holes
Step 4: Secure the flat panel PC to the interface pad by inserting four retention screws
through the bottom of the mounting arm interface pad and into the
flat panel PC. S te p 0 :
4.11 Bottom Panel Switch and Connectors
4.11.1 AT/ATX Mode Selection
AT and ATX power modes can both be used on the EP series panel PC. The selection is
made through an AT/ATX switch on the chassis rear panel (
568H568H568H568H568H568H
Figure 4-21 ). To select AT
mode or ATX mode, follow the steps below.
Step 1: Locate the AT/ATX switch on the chassis rear panel (
569H569H569H569H569H569H
Figure 4-21 ).