WEATHER GUARD 301 through 338 - Manual (Page 6)

WEATHER GUARD® products are protected by one or more of the following trademarks:
U.S. - 842268, 1367500, 1661625, 1663369, 1676545, 1882062, 2228051, 2362167 ; Canada - 282725, 297499;
U.K. - 1400720, 1402476; N.Z. - 296049; Aus. - 761964
- NOTICE -
Any modification or unintended use of this product shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to, or
unintended use of this product.
INSTALLATION PROCEDURE USING BLIND FASTENERS
WARNING
Prior to drilling, so as not to
cut or puncture fuel tanks, fuel
lines, brake lines, electric
wires, etc., check under vehi-
cle for locations.
WEATHER GUARD® PRODUCT
REFINISHING PROCEDURES
All WEATHER GUARD® products are
finished with a polyester powder coat-
ing, and it is important to follow these
procedures to get proper adhesion. As
Knaack LLC cannot control the
finishing of the products, the warranty
for WEATHER GUARD® products on
paint is not applicable on refinished
products.
1. Sand the surface to be painted with
180-200 grit sand paper to rough up
the surface. This should be followed
by wet sanding with a 400 grit wet or
dry paper.
2. Wipe down the sanded surface with
ketone based thinner. This removes
the dust and softens the powder coat-
ing for better paint adhesion.
3. Wipe sanded area with a tack rag
to remove loose dust and particles
before painting.
NOTE: Do not use a lacquer over
the powdered coating.
Black
Oxide
Bolt
Flat
Washer
9/16”
Wrench
Installation
Tool
Blind
Fastener
Place a drop of oil on the black ox-
ide bolt before assembling as
shown on right. Place the Blind
Fastener in the hole and use a 1/2”
or 7/16” wrench to tighten black hex
bolt until the blind fastener is fully
seated. When setting black hex
bolt, it will start out hard. As the
Blind Fastener “bulbs” out it will get
easier, until it bottoms out or sets.
Make sure the Blind Fastener and
Installation Tool do not turn during
installation.
Knaack LLC
ATTN: Warranty Claims
420 E. Terra Cotta Avenue
Crystal Lake, IL 60014
If you have any questions, please call toll free at 1-800-456-7865.
©2013 Knaack LLC
Part No. 24-0144 REV. B ECN 5285 03/13