WEATHER GUARD 301 through 338 - Manual (Page 5)

Rear
Mounting
Bracket
5/16" Lock
Washer
1/2" Hole
5/16-18 Blind
Fastener
5/16-18 x 1"
Hex Hd. Bolt
5/16" Flat
Washer
Figure 5. Stacking PACK RAT®
Drawer Units.
1/2" Hole
5/16-18 Blind
Fastener
5/16" Flat Washer
5/16" Lock Washer
5/16-18 x 1-1/2"
Hex Hd. Bolt
INSET
5
WARNING
The PACK RAT® Drawer Unit
design will carry a generous
amount of heavy cargo. You
must use all of the mounting
materials provided as specified.
Failure to comply could result
in serious personal injury or
damage to your vehicle.
3. Put the upper PACK RAT® unit in
position on top of the lower and mark
the back mounting holes for blind fas-
tener installation.
NOTE: Do not install bolts in the
rear of the upper housing at this
time.
4. With the upper housing in proper
bolting position (with drawer and roll-
ers removed), mark through inner two
obround holes in the front mounting
skid for blind fastener installation.
NOTE: See Figure 5. Inset for
installation details. Do not use
outer-most obround holes, fasten-
ers would obstruct lower unit
drawer travel.
STACKING PACK RAT®
Drawer Units
NOTE: To prevent rust from occur-
ring, touch-up any drilled holes.
NOTE: When stacking PACK RAT®
units in an open vehicle, apply seal-
ant (local purchase) to drilled holed
in the Drawer Unit bodies.
1. With the lower PACK RAT® unit
properly bolted in place, mount the
Rear Mounting Bracket to the top rear
edge of the unit as shown.
2. As with Figure 4., the bracket will
be mounted to the bottom first.
5. With front blind fasteners installed,
fasten the upper housing to the lower.