Warning, Notice, Bolt chart – WEATHER GUARD 1280 User Manual
Page 6
WARNING
Ladders must be secured per ANSI
standard A142.2-1990 paragraph 8.4.4. Ladder
damage will occur from road shock and
vehicle vibration if the ladder is not properly
secured to the ladder rack. Bouncing and side
to side motion of a improperly secured ladder
will cause wear and weaken the ladder. Using
a damaged ladder could lead to a structural
collapse and could result in a serious injury or
death.
- NOTICE -
Any modification or unintended use of this product shall immediately void all manufacturers warranties.
Manufacturer disclaims all liability for injuries to persons or property resulting from any modification to,
or unintended use of this product.
If you have any questions, please give us a call. Call Toll Free 1-800-456-7865
WEATHER GUARD® products are protected by one or more of the following patents or trademarks:
U.S. - 2228051, 842268, 1661625, 1663369, 4509787, 2434963; Canada - 282725, 1218968; U.K. - 1400720; N.Z. - 296049; Aus. - 761964
KNAACK MANUFACTURING COMPANY
420 E. TERRA COTTA AVENUE - CRYSTAL LAKE, ILLINOIS, USA 60014 - 815-459-6020
©2004 Knaack Manufacturing Company
WEATHER GUARD® PRODUCT
REFINISHING PROCEDURES
All WEATHER GUARD® products are finished with a polyester powder coating, and it is important to follow these procedures to get proper adhesion. As Knaack
Manufacturing Co. cannot control the finishing of the products, the warranty for WEATHER GUARD® products on paint is not applicable on refinished products.
1. Sand the surface to be painted with 180-200 grit sand paper to rough up the surface. This should be followed by wet sanding with a 400 grit wet or dry paper.
2. Wipe down the sanded surface with ketone based thinner. This removes the dust and softens the powder coating for better paint adhesion.
3. Wipe sanded area with a tack rag to remove loose dust and particles before painting.
NOTE: Do not use a lacquer over the powdered coating.
10-24 x 2-3/4"
F.H. Screw
5/16-18 x 1-1/2"
Hex Hd. Bolt
5/16-18 x 1-1/4"
Carriage Bolt
5/16-18 x 1"
Carriage Bolt
10-24
5/16-18
Nylon Lock Nuts
Bolt Chart
1/4-20 x 1-1/4"
Hex Hd. Bolt
1/4-20 x 1-1/2"
Carriage Bolt
1/4-20