Run test 2.setup 3.quick test – Vanguard DMOM‐600 User Manual
Page 55

REV 2 Auto‐Ohm 200 S3 / DMOM‐200 S3 / DMOM‐600 USER’S MANUAL
51
3.5.6. Viewing the Test Record Directory
Use the steps below to browse through a directory of the test records stored in the Auto‐Ohm’s
Flash EEPROM memory:
a. Start from the “START‐UP” menu:
Press the
[2]
key (SETUP).
b. The following screen will be displayed:
Press the
[3]
key (SAVE/RESTORE RECORD).
c. The following screen will be displayed:
NOTE
Option 5 (COPY TO THUMB DRIVE) is listed only if a USB Flash drive is
connected to the unit.
Press the
[3]
key (RECORD DIRECTORY).
1. RESTORE RECORD
2. SAVE RECORD
3. RECORD DIRECTORY
4. ERASE RECORD
5. COPY to THUMB DRIVE
1. RECORD ID
2. REVIEW RECORD
3. SAVE/RESTORE RECORD
4. SET TIME
5. SET LANGUAGE
1.RUN TEST
2.SETUP
3.QUICK TEST
time: 14:21:34
date: 05/24/11