Vanguard DMOM‐600 - Manual (Page 31)

REV 2 Auto‐Ohm 200 S3 / DMOM‐200 S3 / DMOM‐600 USER’S MANUAL
27
 If the Dual Ground option was used, the ground current will also be
displayed as shown below:
Press the
[STOP]
key to continue.
If you had selected the normal test option, continue to step i.
If you had selected the automatic test option, continue to step j.
i. The following screen will be displayed:
Auto‐Ohm 200 S3 DMOM‐200 S3/DMOM‐600
Press the
[1]
key (YES) to save the reading. Press the
[1]
key (YES) to print the test
results on the unit’s built‐in thermal
printer (sample test results printouts are
shown in Figure 10 and Figure 11). The
following screen will be displayed:
Press the [1] key (YES) to save the reading.
NOTES
If you had saved a test reading before the current test, the data will still be in
the unit’s working memory. The following screen will be displayed:
KEEP THIS READING?
1. YES
2. NO
PRINT TEST RESULTS?
1. YES
2. NO
KEEP THIS READING?
1. YES
2. NO
TEST RESULTS
497  p
50.01 A
GND CUR: 0.15 AMPS