Vanguard DMOM‐600 - Manual (Page 43)

REV 2 Auto‐Ohm 200 S3 / DMOM‐200 S3 / DMOM‐600 USER’S MANUAL
39
3.5.2. Saving Test Results to a Test Record
After performing a test, the user is presented the option to save the test results to the unit’s
Flash EEPROM or to a USB Flash Drive. If the test results are not saved immediately after
performing a test, they will still remain in the working memory and can be saved later, as long
as a new test has not been performed and the unit has not been turned off. Follow the steps
below to save the test results from the working memory to a test record (the following
procedure can also be used to re‐save a restored test record to a new memory location or to a
USB Flash Drive):
a. Perform a test or restore a test record to the working memory (see section 3.5.3 and
3.5.4), and then start from the “START‐UP” menu:
Press the [2] key (SETUP).
b. The following screen will be displayed:
Press the [3] key (SAVE/RESTORE RECORD)
c. The following screen will be displayed:
NOTE
Option 5 (COPY TO THUMB DRIVE) will be listed only if a USB Flash drive is
connected to the Auto‐Ohm.
Press the
[2]
key (SAVE RECORD).
1. RESTORE RECORD
2. SAVE RECORD
3. RECORD DIRECTORY
4. ERASE RECORD
5. COPY to THUMB DRIVE
1. RECORD ID
2. REVIEW RECORD
3. SAVE/RESTORE RECORD
4. SET TIME
5. SET LANGUAGE
1.RUN TEST
2.SETUP
3.QUICK TEST
time: 14:21:34
date: 05/24/11