Vanguard DMOM‐600 - Manual (Page 29)

REV 2 Auto‐Ohm 200 S3 / DMOM‐200 S3 / DMOM‐600 USER’S MANUAL
25
e. The following screen will be displayed:
Select the burn‐in time by pressing the corresponding numeric key on the keypad.
f. The following screen will be displayed:
Select the ramp time by pressing the corresponding numeric key on the keypad.
NOTE
The ramp time is the time to raise the current from 0A to the test current
and also the time to lower the current from the test current to 0A.
g. The test parameters summary screen will be displayed as shown below:
test parameters
current: 50 amps
burn-in: auto
ramp: 5 sec
"start" to run test
select ramp time:
1. 5 sec
2. 10 sec
3. 20 sec
4. 30 sec
select burn-in time:
1. 5 sec
2. 10 sec
3. 20 sec
4. 30 sec
5. 60 sec
6. 2 min