Tracer TP-8648 Manual M-L AM06054 - Manual (Page 18)

PROBLEM SOLVING:
No fluorescence in the water flow.
• Make sure the dye valve is in the ON position.
• Increase the water flow to increase the dye flow.
• To clean a clog from the small end of the gun, run hot water over it or probe the clog
with a fine wire.
• Add 0.25 ounce (7.4 ml) dye at a time to the bottle.
ADDITIONAL USES FOR THE TracerJet™ SPRAY GUN
FLUSH THE COOLING SYSTEM (See Figure 2)—
CAUTION
Extreme care should be taken when flushing
cooling systems in poor condition
• Loosen the retaining collar and twist off the bottle assembly.
• Twist the stepped nozzle into place.
• Remove the thermostat from the system and turn the heater to the ON position.
• Disconnect the lower cooling hose from the engine block.
• Insert the stepped nozzle into the lower hose and secure with a clamp.
• Turn on the water supply.
• With water running, give short, intermittent blasts of air until water runs out clear.
• Reassemble the system and refill with recommended coolant and pressure test for
leaks.
AIR BLOW FUNCTION (See Figure 3)—
• Remove the bottle assembly from the gun.
• Unscrew the tap fitting from the rear of the gun.
• Install the accessory tail fitting.
• Attach to the air compressor.
PRESSURE WASHER—
• Fill the bottle with detergent or degreaser fluids.
• Rinse the bottle well between uses.
Tracerline ® TP-8640 OPTIMAX Jr™
Cordless, LED Leak Detection Flashlight
To Operate:
Press the button in the end cap once to turn the lamp on. Press it again to turn the lamp
off. The solid-state LED bulb offers long-lived operation (approximately 100,000 hours).
Batteries are included.
Fast, Easy Leak Detection:
• Add the appropriate fluorescent dye and run the engine or A/C system to circulate. (See
instructions included with dyes.)
• For best results, use the OPTIMAX Jr™ in low-light conditions. Wear the TP-9940
glasses provided to make leaks clearly visible.
• Scan the system with the OPTIMAX Jr. You'll see every leak easily by its bright
fluorescent glow.
18 3
1
2
Figure 3
English
1. Remove bottle assembly or
stepped fitting
2. Remove tap fitting
3. Install tail fitting
4. Attach to the air compressor
3
4
French
1. Dépose de la bouteille ou de
la buse
2. Dépose du raccord pour
robinet
3. Installation du raccord arrière
4. Fixation au compresseur d'air
Spanish
1. Remueva el conjunto de la botella
o la boquilla escalonada
2. Remueva el tapón macho de rosca
3. Instale el accesorio de cola
4. Conecte al compresor de aire
German
1. Flaschenteile oder gestuftes
Anschlussstück abnehmen
2. Hahnanschlussstück
abschrauben
3. Endanschlussstück
anbringen
4. Mit Luftkompressor
verbinden