Tracer TP-1509 battery pack A03124-3 User Manual

Tracer For the car

English

TP-1509

12-Volt, DC Rechargeable Battery Pack

IMPORTANT

Please read all operating instructions before using

the TP-1509 12-volt, rechargeable battery pack.

INTRODUCTION
The TP-1509 battery pack is specially designed for use with
Tracerline

12-volt, "instant on" inspection lamps.The TP-1509

battery pack includes a 12VDC, 7.2-amp hour rechargeable bat-
tery and a fused receptacle packed in a nylon carrying case with
an adjustable web shoulder strap. The 12-volt plug receptacle is
used for recharging and connecting to the lamp using its 12-volt
plug. A 120VAC, 12VDC-1000mA battery charger (TP-1506S) is
included.
NOTE: The TP-1509/F battery pack includes a 230VAC, 12VDC-
1000mA charger TP-1506S/F). The TP-1509/J battery pack
includes a 100VAC, 12VDC-1000mA charger (TP-1506S/J).

USING THE TP-1509 BATTERY PACK
The TP-1509 must be fully charged before using.
• Check that the voltage characteristics of the battery charger

match the voltage of the AC outlet.

• Connect the 12-volt plug to the fused battery receptacle.
• Plug the battery charger supplied into a properly regulated

AC outlet.

• The charger requires approximately 12 hours to charge fully,

depending on the discharge level of the battery. The red LED
indicates the charger is being charged, while the green LED
indicates it is ready for use. The charger will not overcharge.
For maximum battery life, recharge the battery within 24 hours
after each use and before a voltmeter registers as low as 10
volts.

• NOTE: Do not completely drain the battery, as this will

reduce its life. Charge the battery at least once every
three months.

• After the battery is charged, first unplug the charger from the

outlet, then unplug it from the fused receptacle.

WARNING

Use only the charger supplied to recharge the

battery. Other chargers may harm the battery and

will void the battery’s warranty. Recharge in a well-

ventilated, dry area. Do not expose the battery to

high temperatures. The maximum allowable

temperature should be below 140°F (60°C).

USING THE TP-1509 BATTERY PACK WITH THE LAMP

1. Plug the 12-volt plug adapter of the lamp into the fused

battery receptacle.

2. Turn on the lamp.
3. Before storing, cleaning or servicing, disconnect the lamp

from the battery pack and allow it to cool. Refer to the operat-
ing instructions packed with the lamp for full information.

(1,1) -1- A03124-3 Battery pack in progress.indd 6/2/11 12:50 PM