Teledyne LeCroy AP033 - Manual (Page 10)

AP033 Active Differential Probe
4 922260-00 Rev A
Standard Accessories
Hard Case
÷10 Plug-on Attenuator
Plug-on AC Coupler
Probe Connection Accessory Kit:
Flex Lead Set (1)
Mini Clip, 0.8 mm (3)
Mini Clip, 0.5 mm (2)
Ground Lead (1)
Offset Pins, Round (4)
Square Pin Header Strip (1)
Manual, AP033 Active Differential Probe Operator’s Manual
Optional Accessories
ADPPS Power Supply
Oscilloscope Software Compatibility
For full control functionality of the probe, Teledyne LeCroy LC series oscilloscopes must have
software version 8.1.0 or higher loaded; all X-Stream oscilloscopes are compatible. The software
version installed in a Teledyne LeCroy oscilloscope can be verified by pressing the SHOW STATUS
button on the front panel (where available), then selecting the System menu choice. The probe can
be used with earlier versions of software; however, probe offset can only be controlled through the
buttons on the probe body. Also, the scale factor will be displayed incorrectly in some modes.
For information on upgrading the software in your oscilloscope, see
teledynelecroy.com/support/softwaredownload, or contact your local Teledyne LeCroy
representative.