Video source, Basic installation – Staub Electronics ZVPRO610 ZEEVEE - SINGLE CHANNEL ANALOG HD DISTRIBUTION OVER COAX User Manual

Page 4

Page 4 of 8

www.zeevee.com

v.08062013

Factory default settings in the product allow ZvPro Series modulators to broadcast up to two HD sources on RF channels
2 and 3 for reception at connected HDTVs.

1. Connect the power supply and apply AC power.
2. Using the Hydra

™

DIN connector cable*, connect the Component (Red/Green/Blue) Video connectors on the AV Cable

to the corresponding Video Outputs on your video source. Use the Composite (Yellow) connector for closed captioning.
Connect either the Digital (Orange) or Analog (Red/White) Audio connectors on the AV Cable to the Audio Outputs on
your video source. Connect the DIN to the AV Input on the ZVPro.

Using the VGA DIN connector cable*, connect the VGA connector to the corresponding VGA Output on your video
source. Use the Analog Audio connector with the corresponding Audio Out port on the Video Source. Connect the
DIN to the AV Input port on the ZvPro.

3. Connect the RF Output of the ZvPro to your

RF network. Default output power of the ZvPro is +25dBmV; it can

be increased to +45dBmV using the Maestro configuration interface.

4. Set the RF input on the TV to Cable Mode (not Air or Antenna).
5. Tune HDTVs to cable channels:

NOTE: Many TVs require a full
channel scan to find the channels.

6. Optional: Go to Advanced

Configuration in Maestro to set
up Delay Matched Audio.

*Note: Hydra Audio/Video and VGA cables are soldseparately and can be purchased from your distributor.

ZvPro

RF A

RF Channel

ZvPro

RF B

RF Channel

AV Input 1

HDTV

Channel

2.1

AV Input 2

HDTV

Channel

3.1

Basic Installation

Video Source

RF Output

Hydra Audio /

Video Cable*

Audio Out

Composite

Video Out

Component

or Close

Cap

tioning

Coax cable connects

to coax network

Connecting Component Video Source

Analog Audio cable

out to audio system

Analog

Digital