IAI America IA-IO-3205-PN - Manual (Page 3)

2
INTELLIGENT ACTUATOR
2. Configuration
2.1 System Configuration
This board is installed in an expansion I/O slot of an X-SEL K-Type controller, or in a standard I/O
slot of a J-Type controller, for use in signal communication with external DIO devices.
Fig. 2-1 Connection Example 1 Fig. 2-2 Connection Example 2
K-Type controller J-Type controller
Multi-point I/O board
PLC, sensor or
other peripheral equipment
PLC, sensor or
other peripheral equipment
Half-pitch I/O flat cable
(w/ connector on one end)
Model: CB-X-PIOH020
Half-pitch I/O flat cable
(w/ connectors on both ends)
Model: CB-X-PIOH020-H6
(Supplied with terminal block TU-MA96)
Dedicated terminal block for
multi-point I/O board
Model: TU-MA96 (NPN specification)
TU-MA96-P (PNP specification)
I/O flat cable (w/o connector on either end)
Model: CB-RCBC-PIO020
(3 cables are supplied with terminal block TU-MA96)