IAI America RS User Manual

Page 29

2. Installation

[2] Installation of the Main Unit

Have the unit attached following the steps below;

1) Unscrew the flat-head screws on the sides of the unit cover and remove the cover.

2) There are 9mm through holes at 4 points on the main unit. Affix the unit with M8 screws.

3) Put the cover back on the unit and affix with the flat-head screws.

Mounting screw

Cover

Flat-head screw

Tightening screws

Use hexagonal socket head bolts for the male threads for installing the base.

Use of high-tension bolts meeting at least ISO-10.9 is recommended.

Use appropriate screws suitable for the attachment holes and attachment grooves.

Do not attempt to use a general-purposed spring washer. Doing so may make the screws even

looser.