Harrington Hoists and Cranes LB Lever Hoist - (L5) User Manual
Page 37
37
6.4.3
Lever Grip
1)
Read ALL instructions below BEFORE applying glue.
2) Remove dirt, water, oil and rust from the area of the Lever where the glue will be applied for the
new grip. Note: Glue is included with the replacement Lever Grip.
3) Make a quick and even application of the glue on the four sides of the Lever as shown in Figure 6-
3. (38) Grip must be installed within 10 seconds after applying the glue to the Lever.
Figure 6-3 Applying Glue to Lever
4) Refer to Figure 6-4 and place (38) Grip on Lever with its inside boss aligned with the boss hole in
the Lever. Make sure boss of (38) Grip is completely seated into the boss hole of the lever.
5) Firmly install (39) Binding Screw through the Grip and Lever Assembly.
Figure 6-4 Fitting Grip onto Lever