Harrington Hoists and Cranes LB Lever Hoist - (L5) - Manual (Page 19)

19
4.4.8 Load Limit Warning Handle Operation
 Operate the hoist by holding the middle of the lever grip.
 The following three (3) signals occur to warn of an excessive load. Refer to Figure 4-2.
- The lever grip DEFLECTS.
- The lever CLICKS.
- The signal window changes from GREEN to RED.
 Stop lifting and lowering immediately when an overload is detected.
 Reset the grip into its straight position (back in place) before continuing to operate the hoist.
External View Internal View
Figure 4-2 Load Limit Warning Handle
4.5 Slip Clutch Option
4.5.1 Slip Clutch Operation
 The L5 Lever Hoist with Slip Clutch is identified as is shown in Figure 4-3.
 The L5 Lever Hoist with Slip Clutch is designed and manufactured to warn an operator of a
dangerous overload while preventing damage to the hoist.
 A greater than rated load will activate the Slip Clutch. This will cause the lever operation to slip
preventing damage to the product.