Gilderfluke&Co old Smart Brick Manual - Manual (Page 70)

" spinup Pioneer ", "Sony disk spinup": These are displayed while spinning up the LaserDisk player.
"LaserLoop Error ": Displayed if an error is encountered during a LaserDisk show.
"LaserDisk early ": This is displayed if we find ourselves before the start of the show on the LaserDisk.
"frame reset cmnd": Displayed in response to this command.
" call vendor ": Displayed if error occurs that requires service from the vendor who installed your
system.
"no LD in config.": Displayed if a LaserDisk-based show is attempted to be played while the Rack
Smart Brick Brain is in Setup mode. As the serial port is being used for the termi-
nal during Setup, it is impossible to play a LaserDisk-based show during Setup.
"stop at end cmnd": Displayed in response to this command.
" stop command ": Displayed in response to this command.
G ILDERFLUKE & C O .¥ 205 S. F LOWER S T .¥ B URBANK , CA 91502 ¥ 818/840-9484 ¥ 800/776-5972 ¥ FAX 818/840-9485
60 of 134