Gilderfluke&Co old Smart Brick Manual User Manual
Page 63

¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥¥
Setup String Commands
ÒOÓ
Setup String 1:
ÒPÓ
Setup String 2:
ÒQÓ
Setup String 3:
ÒRÓ
Setup String 4:
ÒSÓ
Setup String 5:
ÒTÓ
Setup String 6:
ÒUÓ
Setup String 7:
ÒVÓ
Setup String 8:
ÒWÓ
Setup String 9:
These commands are used to setup the strings which are sent out at the starts and ends of shows.
These strings can contain ASCII characters which are sent to and received from the serial port, as well as
special characters which can close the STOP, PLAY and REWIND relay outputs, send the search string for
a LaserDisk player, or cause the Brick Brain to wait until it receives an input on the BLUE, GREEN or PB in-
puts, or a character from the serial port before continuing.
Full details on the Start and End Strings can be found in the next section of the manual.
G
ILDERFLUKE
& C
O
.¥ 205 S. F
LOWER
S
T
.¥ B
URBANK
, CA 91502 ¥ 818/840-9484 ¥ 800/776-5972 ¥
FAX
818/840-9485
53 of 134