Gilderfluke&Co old Smart Brick Manual User Manual
Page 16
7b) If the data has not changed, then the two systems are staying in sync. You can use the cur-
rent setting for the Ôfast forward speedÕ, or you can try speeding it up a bit by lowering the
number in the Ôfast forward speedÕ, and repeat this sequence starting at step 3 to see if it is
now too fast. You should leave a little bit of a safety margin over which the system wonÕt run in
sync to allow for longer wire runs and other factors which might slow the system down further.
8)
Turn dipswitch 8 off if you are done with the IBM Backup Box to return the Smart Brick System to
itÕs normal operating modes.
G
ILDERFLUKE
& C
O
.¥ 205 S. F
LOWER
S
T
.¥ B
URBANK
, CA 91502 ¥ 818/840-9484 ¥ 800/776-5972 ¥
FAX
818/840-9485
6 of 134