SKC Limited EPAM-5000 - Manual (Page 20)

Turning the SKC EPAM-5000 On and Off
Introduction Power can be supplied to the SKC EPAM-5000 either from its internal
battery or from the provided AC power transformer (Battery Charger).
Note: T
HE BATTERY SHOULD BE FULLY CHARGED
before each use. To
charge battery use the EDC supplied charger only. LED indicator on battery
holder will turn green when the battery is fully charged. Charge time is
approximately 22 hours and will run for approximately 24 hours. To check
battery status see Page 5-8.
Power-On Press the ON/OFF key to turn the EPAM-5000 monitor on.
Result: The unit will turn on and the Title Screen will appear.
Power-Off Press the ON/OFF key a second time to turn the SKC EPAM-5000 off.
Up
Arrow
ENT
I/O
Down
Arrow
Enter
Button
On/Off
Button
Keypad
Keypad
Legend
Figure 2.1. Diagram of Key Pad on EPAM-5000.
2 - 2