SKC Limited IOM Sampler - Manual

Page 1 007-09-008 Issue D October 2009
www.skcltd.com
“Calidaptor” Calibration Adaptor
Operating Instructions
391-01 “Calidaptor” Calibration
Adaptor
This Calidaptor is designed for use
with the following sampling heads:
• 225-70A I.O.M. inhalable
sampling head in plastic with
plastic filter cassette
• 225-76A I.O.M. inhalable
sampling head in stainless steel
with stainless steel filter cassette
• 225-79A I.O.M. inhalable
sampling head in plastic with
stainless steel filter cassette
• 225-50 Seven hole sampling head
• 225-52 Single hole sampling head
A Calidaptor designed specifically for
use with the cowled asbestos heads
is also available (part no. 391-05).
The SKC Calidaptor allows the flow
setting of a sampling train without the
problems of holding the head, pump
and adjusting the flow all at the same
time.
A hinged bracket and clamping
screw hold the sampling head
securely against a closed pore foam
ring providing a leak proof joint.
The Calidaptor can either be
screwed directly into the outlet of
SKC rotameters (390, 391 and 392
series only) with an ‘O’ ring providing
a leak proof joint, or connected to
other flow measuring devices using
the supplied screw-in hosetail and a
length of flexible tubing.
Hinged
bracket
Clamping
screw
Foam ring
Calidaptor
bowl
Hosetail
O ring