SKC 210-2000 AirChek 2000 - Manual (Page 18)

15
Setting a Delayed Start
The Delayed Start feature is available in pump version 2.59 or higher.
When sett ing the pump manually for sampling to begin within a 12-hour
timeframe, follow this procedure:
1. With the pump running, press [] to place the pump in HOLD and
enter  within 10 seconds. You are in User Interface Level Two.
2. Press  until SГ appears. Press  or  to set a sample time. This is
required to set a delayed start.
3. Press  until the display reaches the 12-hr/24-hr clock. Press  or 
until the display shows a fl ashing dELA (delayed start).
4. Press . Time will display with hours fl ashing. Press  to increase or
 to decrease the hour. Press  to move to minutes. Press  to increase
or  to decrease the minutes.
The time entered here will be the next occurrence of this time. There
is no a.m. or p.m. designation.
5. Press  until End appears.
6. Press [].
7. The PROG icon and a fl ashing HOLD will appear in the upper left
corner of the display. The pump is now set for delayed start.
If sett ing a delayed start using DataTrac 2000 Soft ware, refer to the
DataTrac 2000 Operating Instructions (included on the soft ware CD).
A programmed delayed start can be viewed in the DataTrac 2000
Scheduler.
Deleting a Delayed Start
This is the same method used to delete a DataTrac 2000 program from the
pump (see Deleting a DataTrac 2000 Program on page 16).
1. With the pump running (will only run in short bursts), press [] to
place the pump in HOLD and enter  within 10 seconds. You are
in User Interface Level Two.
2. Press  to scroll to the fl ashing OFF indicator and press [].
3. Press  until End displays.
4. Press []. The PROG icon should be gone. If not, repeat process until
it disappears.
Setup