Introduction, Pump display, Display icons – SKC 210-2000 AirChek 2000 User Manual
Page 11
8
Pump Display
HOLD:
Flashes when the pump is in HOLD mode (see page 10)
SГ
or S:
Displayed when a sample time is manually programmed
into pump memory (see page 12)
VOL:
Volume of air pumped
SET:
Flashes when changing any setting
CLr:
User Interface option that clears volume and run time
data (see page 13)
ESC:
User Interface Level Two option that exits User Interface
without saving changes (see page 13)
End:
User Interface option that saves changes and exits User
Interface (see page 13)
ADJ:
Displayed during pump fl ow calibration (see page 12)
CAL:
User Interface option that allows pump to be set up for
single or multiple-point calibration using the CalChek
feature (see page 12)
FLOW: Appears
when
fl ow rate is displayed
PROG:
Displayed when a delayed start or a DataTrac 2000
program is loaded into pump memory
Display Icons
Flow Fault:
Flashes during fl ow fault (see page 10)
Battery Charge Level:
Shows battery charge level (see page 6)
AirChek 2000 LCD shown at 100%
Introduction