SKC 210-2000 AirChek 2000 - Manual (Page 16)

13
Time of day
The hour will fl ash. Press  to increase
and  to decrease hour. Press  to
advance to minutes. Once minutes are
fl ashing, press  to increase or  to
decrease minutes. Press  to move to
next parameter.
CLr
Press [] to reset accumulated
run time and volume from pump
memory to zero. See below.
ESC
Press [] to exit User Interface
Level 2 without saving changes to
parameters.
End
Press [] to save changes to
parameters and exit User Interface.
OFF
Appears only when a DataTrac 2000
program or delayed start is loaded in
pump memory. When OFF displays,
press [] to delete and exit the
User Interface. See page 15.
Resetting Run Time Data
To reset accumulated volume and run time data to zero, enter User Interface
Level Two by placing a running pump in HOLD and pressing 
within 10 seconds. Press  until CLr appears on the LCD. Press [] to
clear the run time data. Press  until End appears, and then press [].
The pump is now in HOLD.
CLr does not clear previously set sample time (SГ). See Deleting a
Sample Time on page 16.
Setting Pump Flow Rate
1. With the pump in HOLD, press [] to run the pump and enter
 within 10 seconds. You are now in User Interface Level One.
2. The fl ow rate on the LCD will fl ash. Press  to increase fl ow or  to
decrease fl ow until the desired fl ow rate is displayed.
3. Press  repeatedly until End appears on the LCD.
4. Press [] to save the fl ow rate and exit the User Interface.
5. Press [] again to place the pump in HOLD if desired.
Setup