SKC 210-2000 AirChek 2000 - Manual (Page 14)

11
Verifying Battery Charge Level
The LCD displays an icon that shows the current batt ery charge level
(see Batt ery Operation on page 5). A new batt ery should be fully charged before
operation.
Entering and Navigating the User Interface
The AirChek 2000 User Interface features two levels:
Level One—Set Up Flow Rate allows the user to change fl ow rate,
adjust fl ow rate to a primary standard, or calibrate the pump using the
CalChek feature.
Level Two—Set Up Sampling and Display permits the user to change
display options of temperature (F or C) and atmospheric pressure (ins,
m, or mm), set a sampling time, set 12 or 24-hour clock or delayed start,
set real-time clock, or clear accumulated run time data.
Entering:
• With pump in HOLD, press [] to place pump in RUN and enter
 within 10 seconds. You are in Level One of the User Interface.
• With pump in RUN, press [] to place pump in HOLD and enter
 within 10 seconds. You are in Level Two of the User Interface.
Navigating:
Press  to scroll through parameters. Once LCD shows End,
parameters will repeat until the user exits the User Interface.
Exiting:
Press  until End appears on the LCD. Press []. Any changes
made to parameters will be saved and the pump will continue in its current
mode. Level Two of the User Interface off ers the option of exiting without
saving changes to parameters. Press  until ESC appears on the LCD. Press
[].
Using User Interface - Level One
Flow Set
Set fl ow by pressing  to increase
or  to decrease pump fl ow rate.
Press  to move to next parameter
or the User Interface can be exited
by continuing to press  until End
appears. Press [] to save new
fl ow sett ing and exit. See page 13.
Setup