Post cap & wire managers, Place tv onto post bracket – Salamander Designs SN/PM/A User Manual
Page 5
Post Cap & Wire Managers
7.
A. Using the 4 plastic fasteners (S) attach the post cap (T).
B.
Attach the wire managers (F) by snapping
them into the backside of the post.
Salamander Designs Ltd.
www.salamanderdesigns.com
800-535-5659
© 2012 Salamander Designs Ltd.
Doc No. 500-885 / v10.12 / 5 of 5
S
T
Squeeze to remove.
F
CAUTION
:
Tilt Flat
CAUTION
:
6
.
Place TV onto Post Bracket
NOTE: Two people needed for this step.
Pick-up the TV and guide the pins from the interface bracket (B) onto the post bracket (C) receptacles as shown in Diagram A
(TV may be positioned flat or tilted approximately 7 degrees). Secure the TV in place using the 2 button head screws (Q) with
the hex key (V) at both ends of the post bracket.
Diagram A
Q
V
See also other documents in the category Salamander Designs TV Accessories:
- SD/SPK2/C (2 pages)
- CA/PCM (4 pages)
- CA/PCK (3 pages)
- SD/IRX2 (1 page)
- SD/LS1/W (2 pages)
- SD/SPK1/S (2 pages)
- A2REAR (1 page)
- SAMP/B (1 page)
- SA/RFB/4 (1 page)
- SA/AF/4 (1 page)
- SA/SFB/4 (1 page)
- SA/C/4/BK (1 page)
- SA/HDC/4 (1 page)
- SA/XR20 (2 pages)
- SA/WG1 (1 page)
- SA/DS10/B (2 pages)
- SA/PS (1 page)
- SA/DI2 (1 page)
- SA/UPT2 (1 page)
- SA/PS2 (1 page)
- FX200/XLK (1 page)
- FX200/CK (4 pages)
- SY/FM1 (12 pages)
- SL/PM2/A (2 pages)
- CA/BF2/4/E (1 page)
- CA/TB/N/B (1 page)
- CA/LF/4 (1 page)
- CL/WK1 (2 pages)
- CA/DRM15U (1 page)
- CA/AC20 (1 page)
- SA/BVAC (1 page)
- CL/PM/B (1 page)
- CL/PM2/B (1 page)
- CA/UPT (1 page)
- SD/LOCK (1 page)
- FX200/L/BK (5 pages)
- MA/UA1/BK (2 pages)
- DY102/M (16 pages)
- FX100/S (12 pages)
- PL100/S (12 pages)
- ZM102D/S (12 pages)