Salamander Designs SA/WG1 - Manual

©2005 Salamander Designs Ltd D.oc No. 500-945 / v7.05
Limited Warranty
For five full years Salamander Designs Ltd. will repair or replace, at our option, any product defective in materials or craftsmanship. Salamander Designs Ltd. will not be responsible for any
damage to or destruction of other equipment consequential to our equipment failure. Defective product must be given Return Authorization and is to be returned to the factory prepaid, in the
original carton and packing material. Any damage incurred in a shipment not in original packaging shall be the responsibility of the owner. Warranty repairs will be returned prepaid, via
UPS within the continental U.S.A. only.
Salamander Designs Ltd. • 800-535-5659 • www.SalamanderDesigns.com
SALAMANDER DESIGNS
SALAMANDER MOUNTS
SALAMANDER DESIGNS
SYNERGY WALL GLASS SHELF
- SA/WG1
Parts
1 - Glass Shelf (301-670)
2 . Insert the Flat Nuts down the center posts and tighten with hex key.
2x
1x
Easy Drop In Nuts
(300-565)
1/8” Hex Key (400-070)
Shelf Bracket (301-830)
2x
2x
(300-560) - Flat Nut
2x
Low Head Screw (300-490)
1 . Place the Low Head Screw through the
bracket hole and attach loosely to flat nut.
* If you are adding the shelf to an existing rack use
the Drop-In-Nuts (See Below).
Assembling Bracket Using Drop-In-Nut
Slip into post channel and tighten with hex key.
Nut slants from top left to bottom right as shown.
3 . Place glass shelf. Use the bubble
level to precisely adjust the shelf.
Use the Hex Key to tighten screws.
(P-400-040) - Level
1x