Salamander Designs SD/SPK1/C - Manual

CHAMELEON COLLECTION
™
IN-CABINET SPEAKERS
1
Attach speaker bracket to speaker. Do not over
tighten center screw as this could limit movement.
2
Remove top and speaker grill.
3 (only for cabinets with drawers)
For cabinets with drawers, one must remove the divider panels on either side of the speaker,
cut it 8” from the bottom, and reinstall with top piece rotated 180º to allow for the width of
the speaker to fit between panels.
8”
Cut panel in two pieces 8” from panel bottom. Reinstall panels with top piece rotated 180º
to provide adequate width for the speaker.
3a 3b
Doc No. 500-784 v11.13