Ronan X96S LEVEL GAGE - Manual (Page 24)

20
ITEM FUNCTION
Setpoint Shows, and allows the user to set, the alarm set point
Setpoint2 Shows, and allows the user to set, the second alarm set point 6
Hysterisis Shows, and allows the user to set, the alarm hysterisis percent
Polarity Shows, and allows the user to set, the alarm polarity
Alarm Source is one of the following:
Alarm Source MEANING
Level Operate this TTL output when Level is in alarm as defined by the Alarm Type and set
points.
HeadTemp Operate this TTL output when the head temperature is in alarm as defined by the
Alarm Type and set points
System Alarm Operate this TTL output when the X96S detectes a problem
Detector Flt Operate this TTL outpu twhen a there is a problem with detector
Rad Disc Operate this TTL output when the Rad. Disc. function triggers.
Auto Cal Ref Operate this TTL output when the X96S is performing an automatic calibration
Auto Cal Err Operate this TTL output if the X96S detects an error while performing an automatic
calibration
Not Used This TTL output is not currently in use.
Alarm Type is one of the following:
Alarm Type MEANING
None Alarm not yet set
Low Alarm when the source is equal to or lower than Setpoint
High Alarm when the source is equal to or higher than Setpoint
Range Alarm when the source is equal to or lower than Setpoint or equal to or higher
than Setpoint2
Polarity is one of the following:
Polarity MEANING
Not Driven Normally not driven
Driven Normally driven
Digital Inputs Menu
This menu is used to view and configure the digital inputs. It contains the following item:
ITEM FUNCTION
Input 1 Selecting this item takes the user to the Input 1 menu
Input 2 Selecting this item takes the user to the Input 2 menu
Input 3 Selecting this item takes the user to the Input 3 menu
Input 4 Selecting this item takes the user to the Input 4 menu
Input 5 Selecting this item takes the user to the Input 5 menu
Input 6 Selecting this item takes the user to the Input 6 menu
Input 7 Selecting this item takes the user to the Input 7 menu
Input 8 Selecting this item takes the user to the Input 8 menu
6 The second alarm set point is only used when the alarm type is range.