Keypad quick reference – Robertshaw 9700 User Manual

Page 3

KEYPAD QUICK REFERENCE

SET

FILTER

PROG/MAN

QUICKSET

LOCK

SET - Begins, saves, and advances
programming inputs

PROG/MAN - Sets thermostat to either
program or manual mode. Provides
quick return to normal operating mode
from any menu

QUICKSET - Allows quick programming
by enabling user to program all seven
days at once

LOCK - Accesses keypad “lock” and
“unlock” feature

FILTER - Accesses filter monitor
and status

SYSTEM - Accesses 4 modes of
operation: HEAT, COOL,
AUTO(changeover), or system OFF

FAN -Accesses two modes of fan
operation: auto and on

Decreases or
reverses setting
on display.

AUTO FAN

MAIN DISPLAY (OFF MODE)

A few seconds after power up or RESET, the display shown
above will appear. The thermostat will be in OFF mode.

1. Press SYSTEM button to enter HEAT, COOL, or AUTO*

(changeover) modes of operation.

2. Press PROG/MAN button to enter program or manual

modes. Pressing PROG/MAN returns thermostat to
main display from any menu.

*AUTO may only be entered if "AUTO CHG" was enabled during installation
and you are in PROGRAM mode. (See "CHANGING DIP SWITCH SETTINGS.")

Increases or
advances setting
on display.

SYSTEM

FAN

Symptom

Remedy

Thermostat turns off system before my

Early recovery mode is in effect. This optional feature maximizes comfort

programmed setpoint time.

for occupied periods and eliminates energy wasting demand cycling prior
to set-back periods. See "PROGRAMMING". If you wish to change your
thermostat to normal recovery, see "CHANGING DIP SWITCH SETTINGS".

CHECK FILTER" is indicated in main display.

See "PROGRAMMING - Programming Filter Monitor".

Thermostat does not automatically

Verify that thermostat is in PROGRAM mode and AUTO is indicated

switch from HEAT to COOL mode of

in the display for proper AUTO(changeover) operation.

operation.

Auto (changeover) may have been disabled during installation.
(See "SELECTING AUTO CHANGEOVER".)

Fan runs continuously for hours at

Review programmable fan settings entered during programming.

different times of the day

(See "PROGRAMMING".)

Filter monitor indicates "CHECK FILTER"

Check with your filter supplier and modify Filter Monitor settings to match

too soon for proper filter servicing interval.

your servicing intervals. (See "PROGRAMMING FILTER MONITOR".)

If problems cannot be solved, call:

Technical Support: (800) 445-8299

Monday-Friday 7:30 - 5:30 Central Standard Time