Programming, Unlocking keypad – Robertshaw 9700 User Manual

Page 22

PROGRAMMING

4. Press SET button. The display will show the setpoint temperature

NOTE: Pressing QUICKSET button instead of the SET button will
also save your program settings.

5. Press either

∨ or ∧ button to adjust the setpoint temperature

for the programmed MORN time. (NOTE: Holding down either

∨ or ∧ button scrolls the temperature in 1˚ increments.)

6. Press SET button. The display will show AUTO with FAN.

7. Press either

∨ or ∧ button to program the fan to be in AUTO

(fan cycles with system when required for heating or cooling)
or ON (fan remains on continuously) for the individual daily
setpoint your are programming.

8. Press SET button.

9. Repeat steps 3-8 for the remaining DAY, EVE, and NIGHT

settings.

MON TUE WED THU FRI SAT SUN

MORN

AUTO FAN

MON TUE WED THU FRI SAT SUN

MORN

FAN ON

MORN

MON TUE WED THU FRI SAT SUN

SET

5. Press SET button to save second digit. The third digit will flash.

6. Press

∨ or ∧ button to enter the third (right) digit.

7. Press SET button to save third digit. "Lock” appears on the

screen and your combination is now saved.

Unlocking keypad:

1. Press LOCK button. The display will show “000.”

2. Follow steps 2-7 as listed above in “Setting your combination and

lock keypad.” If combination is correct, the word “LOCK” will
disappear from the display and the program may be changed. If
combination is not correct, the thermostat will display the word
“no” and return to normal display mode.

If, for any reason, you have forgotten your combination or are
unable to unlock the keypad, press reset button on the rear of the
thermostat. See “REMOVING THERMOSTAT FROM SUBBASE”
and “Resetting the Thermostat.” Pressing reset will erase ALL
programmed information as well as time clock and day of week.

PROGRAMMING

RESET

SET

LOCK

MON
LOCK

HEAT

AUTO FAN

MANUAL