Ransburg MicroPak LECU5004 - Manual (Page 38)

MicroPak - Change Summary
Ransburg
35 LN-9218-00.13
This manual was published to replace Service
Manual LN-9218-00.12, MicroPak, to make the
following changes:
1. Removed di/dt communication information from
the Remote Mode paragraph in “Operation” and
referred user to the I/O tables for Discrete I/O
Module or Serial Node Adapter as appropriate.
2. Corrected the Discrete Inputs table in the Input/
Output Signals section of “Operation”. A signal
sent to J7 Pin 15C activates di/dt inhibit (not delay)
and a signal sent to J7 Pin 17C includes a di/dt
delay of 5 seconds with the activation of the fluid
trigger for EFM guns.
MANUAL CHANGE SUMMARY
Previous revision Service Manual LN-9218-00.12,
MicroPak, included the following changes from its
prior revision (.11):
1. Revised “Figure 2: MicroPak Controller w/
LEPS5002 or 74793 Cascade (RansPak 1000)” in
the “Installation” section. Cable connection point
1 is not connected (“N/C”) inside the MicroPak. It
was erroneously shown as “GND” prior.
2. Revised “Figure 6: Switch Settings” in the
“Operation” section. Added the RP-404 cascade
and respective switch settings.
3. Revised various references within the entire
manual to add RP404 cascade.