Ransburg MicroPak LECU5004 - Manual (Page 10)

MicroPak - Introduction
Ransburg
7 LN-9218-00.13
Controls:
1. All communication to Controller by CANBus
2. Direct A-B RIO communication via additional
Node Adapter Module (Part# LECU4012) or
Serial Node Adapter + Module (Part #78553)
(One Node Adapter per rack)
3. Discrete signals available via additional I/O
Module (Part# 76037) in place of Node
Adapter with levels as shown below
Analog In: (0-10 VDC or 4-20 mA DC)
kV Set
Current Set
(Overcurrent Setpoint)
(Di/dt Sensitivity)
Analog Out: (0-10 VDC)
OUTPUT kV
OUTPUT CURRENT
Discrete Out: (Dry Contact)
HV ON
FB FAULT
HV READY
OVER CURRENT FAULT
LOCAL
HV RESET
Discrete In: (24 VDC Source or Sink)
HV OFF
HV ON
FLUID TRIGGER
AIR TRIGGER / SEQUENCER
START
Trigger Out: (24 VDC, 150 mA Maximum)
(For EFM Gun) AIR TRIGGER
Electrical
Output: 100 kV @ 0 µA
125 µA @ 0 kV
Cascade Size: HP404 1.50” X 1.56” x 7.0”
RP404 4” X 4” X 12”
Output: 100 kV, 1000 µA
(75% Duty Cycle)
Cascade Size: 4” X 4” X 12”
Output: 100 kV, 1000 µA
(75% Duty Cycle)
Cascade Size: 14” X 12” X 12”
MicroPak with HP404 / RP404 Cascades
MicroPak With RP1000 Cascade
MicroPak With LEPS5002 Cascade
Output: 100 kV, 0 µA
(85 µA Max.)
Cascade Size: 1.50” X 1.56” X 7.0”
MicroPak With HP404 FM Cascade
Output: 100 kV @ 0 µA
240 µA @ 0 kV
Cascade Size: 1.50” X 1.56” X 7.0”
MicroPak With HP505 Cascade