Ransburg Turbodisk Applicator Assembly A11376 - Manual (Page 71)

Turbodisk Applicator - Parts Identification
66
78175-01 Air Motor Assembly, Clockwise Rotation, without Exhaust Adapter 0 70879-406
78175-02 Air Motor Assembly, Counter-Clockwise Rotation, with Exhaust Adapter 1 70879-406
78175-11 Air Motor Assembly, Counter-Clockwise Rotation, without Exhaust Adapter 0 70879-456
78175-12 Air Motor Assembly, Counter-Clockwise Rotation, with Exhaust Adapter 1 70879-456
Part # Description A
TABLE "A" (Figure 18)
B
1
1
** See "Parts List Bullet Definition Table"
* See corresponding column in Table "A"
1 Housing Assembly, Machined, Turbodisk Upgrade 78174-00 1
2 Screw, #8-32 x 5/16" Long, Slotted Round Head 7735-10C 8
3 Lock Washer, #8 Helical Spring 7734-03 8
4 Plug, Protective LS0135 1
5 Muffler, 1" NPT Polyethylene Exhaust 78163-00 1
6 Fitting, Machined, Exhaust Muffler Adapter 78173-00 A*
7 Identification Cap, 1/2" OD Tube, Green 78169-00 2
8 Fitting, 1/2" NPT x 1/2" OD Tube 78168-00 2
9 O-Ring, 4.239" ID x .070" CS, Solvent Resistant 7554-74 2
10 Screw, #8-32 x 3/8" Long, Socket Head Set 7716-12C 3
11 Air Motor Assembly, Turbodisk B* 1
12 Screw, #6-32 x 1/2" Long, Socket Head Cap 10773-16C 6
13 Nameplate, Turbodisk 70870-00 1
14 Drive Screw 7612-43 4
Item #
78175-XX TURBODISK AIR TURBINE ASSEMBLY -
PARTS LIST (Figure 18)
Part # Description Qty
2
3
5
Tighten screws alternately to a final torque reading of 10 lbs•in (1.13 Nm).
Apply Petrolatum jell, SSL-11, to o-rings prior to assembly.
Apply 7969-10 thread sealer to male pipe threads prior to assembly.
The exhaust adapter is required only when the orientation of the fluid valving will not allow the exhaust muffler
to be installed directly into the turbine housing. If the installed system provides an interference, then it may be
possible to re-orient the fluid valving so that the exhaust adapter is not required.
5
** PARTS LIST BULLET DEFINITION TABLE (Figure 18)
3
2
1
AA-07-02.1