Ransburg Turbodisk Applicator Assembly A11376 - Manual (Page 20)

Turbodisk Applicator - Operation
15
ELECTROSTATIC VOLTAGE
In the system, the high voltage is supplied to the Tur-
bodisk by either the MicroPak Industrial power supply
system or Voltage Master series power supplies.
The MicroPak industrial power supply uses proven
high voltage generator technology that is micro-
processor controlled for diagnostics and communi-
cation. The controller is packaged in standard rack
mounted Eurocard format for easy access and system
integration.
The Voltage Master power supplies are general pur-
pose heavy duty power supplies with years of proven
reliability. They have variable voltage control, many
safety features, and remote analog voltage control
capabilities.
TARGET DISTANCE
The distance between the Turbodisk and the target
will affect the finish quality, penetration, and ef-
ficiency. Closer distances give wetter finishes and
greater efficiency, while greater distances give drier
finishes. The recommended normal disk edge to
target range is 12-inches (305mm) minimum for
optimum performance.
None
Conical Disk Assy., Serrated, 6", Aluminum, Not Anodized
Conical Disk Assy., Serrated, 6" Aluminum, Anodized
Conical Disk Assy., Serrated, 9", Aluminum, Not Anodized
Conical Disk Assy., Serrated, 9", Aluminum, Anodized
Conical Disk Assy., Serrated, 12", Aluminum, Not Anodized
Conical Disk Assy., Serrated, 12", Aluminum, Anodized
Uni-Disk Assy., 6", Aluminum, Not Anodized
Uni-Disk Assy., 8", Aluminum, Not Anodized
Uni-Disk Assy., 10", Aluminum, Not Anodized
Uni-Disk Assy., 12", Aluminum, Not Anodized --
20485-62
20485-65
20485-92
20485-95
20485-122
20485-125
19830-06
19830-08
19830-10
19830-12
Disk Type Part Number
TYPICAL MAXIMUM SAFE OPERATING SPEEDS
--
40,000
40,000
25,000
25,000
15,000
15,000
27,000
23,000
15,000
15,000
Max. RPM
AA-07-02.1