Kasco Marine Pond Aerator & Water Circulator - Manual (Page 10)

10
3. Adjustment Bracket (1)
4. Angle Bracket (3)
5. Draw Band (1)
6. U-Bracket (2)
7. Spacer Bracket (2)
8. 1/4” x 1/2” Stainless Steel Bolt (8)
9. 1/4” x 1” Stainless Steel Bolt (3)
10. 1/4” x 1-1/4” Stainless Steel Bolt (2)
11. 1/4” Stainless Steel Lock Nut (8)
12. 1/4” Stainless Steel Hex Nut (2)
13. 1/4” Stainless Steel Lock Washer (5)
14. 50’ Black Nylon Ropes (2)
15. Nylon Tie (1)
Circulator Tools & Supplies Needed
A. Anchors or stakes for installing unit (2)
B. 120V or 240V Electrical Supply near pond on a
post (1)
C. 12” pieces of 1” galvanized pipe for weighting
ropes (optional) (2)
D. 9/16” (14mm) & 7/16” (11mm) Nut Driver
E. 9/16” (14mm) & 7/16” (11mm) Socket
F. Adjustable crescent wrench
G. 7/16” Wrench (1)
H. 7/16” Socket & Wrench (1)
I. Felt-tip marker (1)
Circulator (CF Model) Assembly
STEP ONE
Remove all contents from package and place on a clean,
flat surface. Inspect the shipment for any damages. Make
sure you have all the parts needed.
STEP TWO
Position the Float (Part B1)upside down (lengthwise chan-
nels facing up) and place the Base Strap (Part B2) so the
three holes in the Base Strap align with the three threaded
holes that comprise the lengthwise midline of the Float.
float for each foot of depth (Ex. A 6 foot deep pond
would require an anchor 18 feet horizontally from the
float.)
For ease of removal, you may choose to keep at least
one anchor within reach from shore, just below the
water’s surface.
Correct Anchoring
Incorrect Anchoring
STEP TWO (ALTERNATE INSTALLATION)
In ponds where the water level fluctuates significantly, you
may need to suspend a small weight (12” of 1” galvanize
pipe works well) at the mid-point of the rope to take up any
slack as the water level drops. The weight should be light
enough so the Aerator can rise as the water level rises. This
can also help hide ropes by sinking them further below the
surface.
Normal Water level
Power Cord
Anchor Rope
Secondary Weight
Low Water Level
Kasco Power
Control Box
High Water Level
STEP THREE
At this time the Aerator is ready for operation. It can
be plugged into the power supply at the pond edge.
ENJOY YOUR NEW KASCO EQUIPMENT!
Circulator Parts (CF Models)
Circulator (Unit with cord or stub cord) (1)
Float in separate box (1)
1. Float (1)
2. Base Strap (1)