Accton Technology ES4524D - Manual (Page 98)

Configuring Event Logging
9-6
9
CLI – Enter the IP address of at least one SMTP server, set the syslog severity level
to trigger an email message, and specify the switch (source) and up to five recipient
(destination) email addresses. Enable SMTP with the logging sendmail command
to complete the configuration. Use the show logging sendmail command to display
the current SMTP configuration.
Console(config)#logging sendmail host 192.168.1.4 38-1
Console(config)#logging sendmail level 3 38-2
Console(config)#logging sendmail source-email
[email protected] 38-2
Console(config)#logging sendmail destination-email
[email protected] 38-3
Console(config)#logging sendmail 38-3
Console(config)#exit
Console#show logging sendmail
38-4
SMTP servers
-----------------------------------------------
1. 192.168.1.4
SMTP minimum severity level: 4
SMTP destination email addresses
-----------------------------------------------
1. [email protected]
SMTP source email address: [email protected]
SMTP status: Enabled
Console#