Accton Technology ES4524D - Manual (Page 71)

Setting the Switch’s IP Address (IP Version 4)
5-3
5
Using DHCP/BOOTP
If your network provides DHCP/BOOTP services, you can configure the switch to be
dynamically configured by these services.
Web – Click System, IP Configuration. Specify the VLAN to which the management
station is attached, set the IP Address Mode to DHCP or BOOTP. Click Apply to
save your changes. Then click Restart DHCP to immediately request a new
address. Note that the switch will also broadcast a request for IP configuration
settings on each power reset.
Figure 5-2 IPv4 Interface Configuration - DHCP
Note: If you lose your management connection, make a console connection to the
switch and enter “show ip interface” to determine the new switch address.
CLI – Specify the management interface, and set the IP address mode to DHCP or
BOOTP, and then enter the “ip dhcp restart” command.
Renewing DCHP – DHCP may lease addresses to clients indefinitely or for a
specific period of time. If the address expires or the switch is moved to another
network segment, you will lose management access to the switch. In this case, you
can reboot the switch or submit a client request to restart DHCP service via the CLI.
Console#config
Console(config)#interface vlan 1
45-1
Console(config-if)#ip address dhcp 59-1
Console(config-if)#end
Console#ip dhcp restart
59-3
Console#show ip interface 59-4
IP Address and Netmask: 192.168.0.100 255.255.255.0 on VLAN 1,
Address Mode: DHCP
Console#