Accton Technology ES4524D - Manual (Page 407)

45-1
Chapter 45: Interface Commands
These commands are used to display or set communication parameters for an
Ethernet port, aggregated link, or VLAN.
interface
This command configures an interface type and enter interface configuration mode.
Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit/port
- unit - Stack unit. (Range: Always 1)
- port - Port number. (Range: 1-24/48)
• port-channel channel-id (Range: 1-24)
• vlan vlan-id (Range: 1-4093)
Default Setting
None
Table 45-1 Interface Commands
Command Function Mode Page
interface Configures an interface type and enters interface configuration
mode
GC 45-1
description Adds a description to an interface configuration IC 45-2
speed-duplex Configures the speed and duplex operation of a given interface
when autonegotiation is disabled
IC 45-2
negotiation Enables autonegotiation of a given interface IC 45-3
capabilities Advertises the capabilities of a given interface for use in
autonegotiation
IC 45-4
flowcontrol Enables flow control on a given interface IC 45-5
media-type Force port type selected for combination ports IC 45-6
shutdown Disables an interface IC 45-6
clear counters Clears statistics on an interface PE 45-7
show interfaces status Displays status for the specified interface NE, PE 45-8
show interfaces
counters
Displays statistics for the specified interfaces NE, PE 45-9
show interfaces
switchport
Displays the administrative and operational status of an
interface
NE, PE 45-10