Accton Technology ES4524D - Manual (Page 554)

IPv6 Interface Commands
60-22
60
Example
Related Commands
ping (59-5)
ipv6 neighbor
This command configures a static entry in the IPv6 neighbor discovery cache. Use
the no form to remove a static entry from the cache.
Syntax
ipv6 neighbor ipv6-address vlan vlan-id hardware-address
no ipv6 mtu
• ipv6-address - The IPv6 address of a neighbor device that can be reached
through one of the network interfaces configured on this switch. You can
specify either a link-local or global unicast address formatted according to
RFC 2373 “IPv6 Addressing Architecture,” using 8 colon-separated 16-bit
hexadecimal values. One double colon may be used in the address to
indicate the appropriate number of zeros required to fill the undefined fields.
• vlan-id - VLAN ID (Range: 1-4093)
• hardware-address - The 48-bit MAC layer address for the neighbor device.
This address must be formatted as six hexadecimal pairs separated by
hyphens.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Address Resolution Protocol (ARP) has been replaced in IPv6 with the
Neighbor Discovery Protocol (NDP). The ipv6 neighbor command is similar
to the mac-address-table static command (page 50-1) that is implemented
using ARP.
• Static entries can only be configured on an IPv6-enabled interface.
• The switch does not determine whether a static entry is reachable before
placing it in the IPv6 neighbor discovery cache.
Console# ping ipv6 2001:0DB8::3/64 repeat 5
Which outside interface [1]:1
Type ESC to abort.
Sending 5, [100]-byte ICMP Echos to 2009:DB9:2229::80, timeout is 2 seconds.
!!!!!
Success rate is 100 percent
round-trip min/max/avg = 10/30/14.000000 ms
Console#