Accton Technology ES4524D - Manual (Page 337)

40-1
Chapter 40: SNMP Commands
Controls access to this switch from management stations using the Simple Network
Management Protocol (SNMP), as well as the error types sent to trap managers.
SNMP Version 3 also provides security features that cover message integrity,
authentication, and encryption; as well as controlling user access to specific areas of
the MIB tree. To use SNMPv3, first set an SNMP engine ID (or accept the default),
specify read and write access views for the MIB tree, configure SNMP user groups
with the required security model (i.e., SNMP v1, v2c or v3) and security level (i.e.,
authentication and privacy), and then assign SNMP users to these groups, along
with their specific authentication and privacy passwords.
Table 40-1 SNMP Commands
Command Function Mode Page
snmp-server Enables the SNMP agent GC 40-2
show snmp Displays the status of SNMP communications NE, PE 40-2
snmp-server community Sets up the community access string to permit access to
SNMP commands
GC 40-3
snmp-server contact Sets the system contact string GC 40-4
snmp-server location Sets the system location string GC 40-4
snmp-server host Specifies the recipient of an SNMP notification operation GC 40-5
snmp-server enable traps Enables the device to send SNMP traps (i.e., SNMP
notifications)
GC 40-7
snmp-server engine-id Sets the SNMP engine ID GC 40-8
show snmp engine-id Shows the SNMP engine ID PE 40-9
snmp-server view Adds an SNMP view GC 40-10
show snmp view Shows the SNMP views PE 40-11
snmp-server group Adds an SNMP group, mapping users to views GC 40-11
show snmp group Shows the SNMP groups PE 40-13
snmp-server user Adds a user to an SNMP group GC 40-14
show snmp user Shows the SNMP users PE 40-15