Accton Technology ES4524D - Manual (Page 510)

Multicast Filtering Commands
57-2
57
ip igmp snooping vlan static
This command adds a port to a multicast group. Use the no form to remove the port.
Syntax
[no] ip igmp snooping vlan vlan-id static ip-address interface
• vlan-id - VLAN ID (Range: 1-4093)
• ip-address - IP address for multicast group
• interface
• ethernet unit/port
- unit - Stack unit. (Range: Always 1)
- port - Port number. (Range: 1-24/48)
• port-channel channel-id (Range: 1-24)
Default Setting
None
Command Mode
Global Configuration
Example
The following shows how to statically configure a multicast group on a port:
ip igmp snooping version
This command configures the IGMP snooping version. Use the no form to restore
the default.
Syntax
ip igmp snooping version {1 | 2}
no ip igmp snooping version
• 1 - IGMP Version 1
• 2 - IGMP Version 2
Default Setting
IGMP Version 2
Command Mode
Global Configuration
Command Usage
• All systems on the subnet must support the same version. If there are legacy
devices in your network that only support Version 1, you will also have to
configure this switch to use Version 1.
• Some commands are only enabled for IGMPv2, including ip igmp
query-max-response-time and ip igmp query-timeout.
Console(config)#ip igmp snooping vlan 1 static 224.0.0.12 ethernet 1/5
Console(config)#