Fairbanks 2800 Series Intrinsically Safe Instrument - Manual (Page 28)

Section 2: Operation
01/12 28 50647 Rev. 9
2.3.4. TARE WEIGHTS, CONTINUED
ENTERING ID Numbers
1. Place the instrument into the Weighing mode.
2. Press the key.
─ The current ID number or id none will be displayed.
3. Use the numeric keypad to assign an ID number.
─ A maximum of six digits, 0 through 999999.
4. Press the key to save the displayed ID number and to return the
instrument to the Weighing mode.
─ The ID number is printed as part of each print cycle if selected in the IO
Output Programming.
Peak Hold Function
The PEAK HOLD (P hoLd) function is used to determine, display, and print the
largest Net weight data achieved during a weighing cycle. A weigh cycle ends when
the Print command is given, or when the peak Net weight is manually cleared by the
CLEAR
key. PEAK HOLD tracks only Net weight, and operates independently of the
display. The peak weight can either be a positive or a negative number, determined
by the absolute weight value. This means that if a positive peak is displayed, a
negative weight value of greater absolute value could update the peak information in
the same cycle.
If the P hoLd option is activated in the IO Menu, then pressing the START key
enables this function
─ It allows the viewing of the current peak net weight.
Pressing
ENTER
returns the display to the Weighing mode.
─ The P hoLd feature works in the Gross or Net Weighing modes.
1. Place a container on the scale.
2. Press the AUTOTARE key, or enter in a known TARE Weight.
3. Press the
START/PEAK
key to view the current Peak Net Weight.
4. Press the ENTER key to enable the feature and return to the Weighing mode.
5. Perform the desired number of weighment’.