Chapter 4 software configuration – PROLiNK H5004N Wireless-N User Manual
Page 9
PROLiNK
®
H5004N User Manual
www.prolink2u.com
Version 1.00 (Jan’10)
8
Chapter 4
Software Configuration
The DSL device is an ADSL2+ wireless router. When you power on the device, the system will boot up
and connect to ADSL automatically. The system provides a PVC for bridge test by default. The default
configurations for the system are listed below.
z
LAN IP address: 192.168.1.1, Netmask: 255.255.255.0
z
UART setting: 115200bps, 8 bits, no parity, 1 stop bit, no flow control.
z
VPI/VCI
for
ATM:
0/35
z
ADSL
Line
mode:
Auto-detect.
User can change settings via WEB browser. The following sections describe the set up procedures.
Please set your PC’s Ethernet port as follow:
z
IP
address:
192.168.1.XXX (e.g. 192.168.1.10)
z
Netmask:
255.255.255.0
Access the Web Console:
z
Start your web browser.
z
Type the Ethernet IP address of the modem/router on the address bar of the browser. Default
IP address is 192.168.1.1.
z
The Enter Network Password dialog box appears. Default Username: admin Password:
password