Aiphone GH SERIES 0207 AIC User Manual

Page 35

- 35 -

9-1

Programming (GH-MK)

• Make sure that all units are installed and wired properly. Turn

on the power switch to GH-BC. Program the resident
information (names and room numbers) in advance.

a. Programming with a PC
• You can use a PC to enter data and write in or change resident

names.

• Use the connection cable that comes with GH-MK to connect

your PC to GH-MK.

• In your PC, install the setup tool program from the CD that

comes with GH-BC.

∗ For information on how to use the setup tool, see the text (.txt)

file that is installed in the same folder as the setup tool (.exe).

Save programmed data and resident information data to your

PC is recommended.

b. Programming with GH-MK
• Confirm that "AIPHONE" is shown on the Display, indicating

that the system is in standby mode.

• First, set the system to program mode. (For details, see 9-2.)
∗ Before you begin programming, we recommend that you

1. Menu 5: Programming
2. Lift the handset (security guard station).
3. Press the talk button on the first residential station. The

corresponding communication channel will be established.

For other GH-MK, lift the handset.

4. Use the search button to display the assigned name and then

press the call button.

5. If an electronic beep is emitted once, the residential station has

been set up successfully. (If an electronic sound is emitted
twice, it is for the second residential station.) Press the talk
button to end the communication channel. Go to the location of
each residential station and program them one by one in
accordance with the programming procedures.

6. Replace the handset (security guard station).

1. If you have forgotten your ID code, set the switch (#1) to

ON for approximately 2 seconds. The ID code will be reset
to the default setting of "

∗1111".

2. While data is being entered into the system, the entire

system cannot function (including emergency calls).

NOTE: If you attempt to setup a fifth residential station when

four residential stations have already been established, an
alarm beep will be emitted. To cancel the communication
link, display the assigned name and press the call button
for at least 3 seconds. A continuous beep will be emitted
to verify the communication link has been cleared.