Atlantis Land WEBSHARE 3G 244WN - Manual (Page 48)

48
ESSID The ESSID is the unique name of a wireless access point (AP)
to be distinguished from another. For security purpose, change
the default WebShare244WN to a unique ID name to the AP
which is already built-in to the router’s wireless interface. It is
case sensitive and must not excess 32 characters. Make sure
your wireless clients have exactly the ESSID as the device, in
order to get connected to your network.
ESSID Broadcast It is function in which transmits its ESSID to the air so that
when wireless client searches for a network, router can then be
discovered and recognized. Default setting is Enabled.
• Disable: If you do not want broadcast your ESSID.
Any client uses “any” wireless setting cannot
discover the Access Point (AP) of your router.
• Enable: Any client that using the “any” setting can
discover the Access Point (AP) in the wireless
network.
Regulation Domain There are seven Regulation Domains for you to choose from,
including North America (N.America), Europe, France, etc. The
Channel ID will be different based on this setting
Channel Widht Select either 20 MHz or 20/40 MHz for the channel
bandwidth. The higher the bandwidth the better the
performance will be.
Channel ID Select the wireless connection ID channel that you would like to
use.
TX Power Level It is a function that enhances the wireless transmitting signal
strength. User may adjust this power level from minimum 1 up
to maximum 100
Connected Representing in true or false. That it is the connection status
between the system and the build-in wireless card.
AP Mac Address It is a unique hardware address of the Access Point
AP Firmware
Version
The Access Point firmware version.
WMM Enable or disable the WMM support.