Atlantis Land WEBSHARE 3G 244WN - Manual (Page 123)

123
2 Make sure that there is not an console session running.
3 Check that you have enabled web service access. If you have
configured a secured client IP address, your computer’s IP address
must match it. Refer to the chapter on remote management for
details.
4 For WAN access, you must configure remote management to allow
server access from the Wan (or all).
5 Your computer’s and the ADSL Router’s IP addresses must be on the
same subnet for LAN access.
6 If you changed the ADSL Router’s LAN IP address, then enter the
new one as the URL.
7 Remove any filters in LAN or WAN that block web service.
8 See also Section A.9.
The web configurator does not display properly.
Steps Corrective Action
1 Make sure you are using Internet Explorer 5.0 and later versions.
2 Delete the temporary web files and log in again.
In Internet Explorer, click Tools, Internet Options and then click the
Delete Files ... button.
When a Delete Files window displays, select Delete all offline
content and click OK. (Steps may vary depending on the version of
your Internet browser.)
A.4 Login Username e Password
I forgot my login username and/or password.
Steps Corrective Action
1 If you have changed the password and have now forgotten it, you
will need to upload the default configuration file. This will erase all
custom configurations and restore all of the factory defaults
including the password.
2 Press the RESET button for 10 seconds, and then release it. When
the PWR LED begins red, the defaults have been restored and the
ADSL Router restarts. Or refer to the Resetting the ADSL Router