Minuteman Port A Scrub with Power Pack - Manual (Page 35)

35
Maintenance and Care
5.5.1 Filling the solution tank
Fill the solution tank (Fig. 16/1) before
starting work or as necessary.
The solution temperature must
not exceed 50 °C!
1. Switch off the machine using the
main switch and disconnect the bat-
tery plug.
2. Open the housing cover and remove
the solution tank (Fig. 16/1).
3. Fill fresh water up to the marking, ap-
prox. 10 liters (add a cleaning agent
if necessary).
4. Reinstall the solution tank.
Observe the applicable laws
and local regulations when dis-
posing of cleaning agents!
5.5.2 Cleaning the solution filter
Check the solution filter (Fig. 16/2) daily
and clean or change it as necessary.
1. Switch off the machine using the
main switch and disconnect the bat-
tery plug.
2. Open the housing cover and discon-
nect the solution filter (Fig. 16/2)
from the hose.
3. Rinse the solution filter with water or,
if necessary, install a new one.
5.5.3 Check the seal
Check the solution tank seal (Fig. 16/3)
weekly and clean or change as neces-
sary.
1. Switch off the machine using the
main switch and disconnect the bat-
tery plug.
2. Open the housing cover and remove
the seal (Fig. 16/3) from the housing
cover.
3. Clean the seal and reinstall it or in-
sert a new one.