Minuteman Port A Scrub with Power Pack - Manual (Page 31)

31
Maintenance and Care
5.4 Battery system
The Power Pack (Fig. 13/1) represents
the power supply for the Port A Scrub.
It is not permitted to clean the
machine with a pressure wash-
er or steam blaster.
Initial battery charge
Before starting the machine up
for the first time, the batteries
to be used must be fully
charged, properly, by imple-
menting the initial battery
charge routine. Minuteman as-
sumes no liability for damage
to the battery caused by a fault
when the battery is charged for
the first time.
5.4.1 Charging batteries
We recommend charging the battery
immediately if the battery indicator (Fig.
14/6) on the Port A Scrub lights up red
during operation. The batteries are
charged using the integrated battery
charger.
1. Connect the battery plug (Fig. 13/3)
to the battery socket on the Power
Pack (as illustrated in the figure).
2. Insert the power plug (Fig. 13/2) in a
mains power socket.
3. The charge status is indicated by
LEDs A to C.
- LED (A) lights up yellow = <80%
charge
- LED (B) lights up yellow = >80%
charge
- LED (C) lights up green = 100%
charge
4. Following the charging process, dis-
connect the power plug again.
Errors are signaled by the red LED (D).
Contact your authorized Minuteman
service center in the event of an error!
Fig.13
1
A
3
2
B C D